The tool for sharpening along the radius is intended for grinding along the radius of the end multi-edge tool and incisors.

The device is attached to the machine table by means of T-shaped slots through the housing. On the vertical axis, a faceplate is mounted on the bearings on which the cross table is mounted. This axis is the base from which the value of the radius obtained at sharpening is measured.

The cross table moves in two mutually perpendicular directions on the slide guides of the "Swallowtail" type. Moving the table sets the required position of the tool relative to the axis of the faceplate. On the cross table can be installed universal head 3Е642Е.P1, used for:

  • Sharpening of the end tool (with a set of adapter bushings and ramrods for fixing the end tool);
  • Sharpening of incisors with a circular holder with fastening them in a collet clamp 3Е642Е.P40.);
  • Device for sharpening cutters with rectangular holder 3Е642Е.P13.020);
  • Device for external circular grinding VZ-318.P17, used for the treatment of spherical surfaces and installed on a cross table (without an upper swivel plate).

Write a review

Note: HTML is not translated!
    Bad           Good
basic_captcha

The device for sharpening of core drills and step drills 3Е642Е.P19

  • Product Code: 3Е642Е.P13
  • Availability: In Stock