• Device for sharpening circular saws on the end face of the teeth of the VZ-318.P56

The device is designed for sharpening circular saws at the end of the teeth.

Install the saw. Set the sharpened tooth surface parallel to the longitudinal movement of the table by turning the universal headstock around the horizontal axis. Set the spindle axis of the grinding head so that it passes through the front surface of the tooth to be sharpened. Bring the prop to the touch with the front surface of the tooth to be sharpened. To set the axis of the circle relative to the ground surface so as to obtain a preset angle at the end of the tooth. Feeding is carried out by vertical movement of the grinding head.

The parameters marked with (*) are specified at the stage of the technical task coordination.
The landing diameter of the saw, mm232,50,80
The largest diameter of the sharpened tool, mm 200-450
Overall dimensions (LxWxH), mm365х310х315

Write a review

Note: HTML is not translated!
    Bad           Good
basic_captcha

Device for sharpening circular saws on the end face of the teeth of the VZ-318.P56

  • Product Code: VZ-318.P56
  • Availability: In Stock