• Device for sharpening drills with the center and cuts VZ-384.P15

Device for sharpening drills with center and undercutters.

The device is installed on the upper transverse table of the machine. The drill bit is installed and oriented in relation to the grinding wheel. Consistently produced a sharpening of the main back surface, sharpen the cuts on the two surfaces, the sharpening of the guiding center along the edges.

The parameters marked with (*) are specified at the stage of the technical task coordination.

The diameter of the sharpened drill bit, mm
6..32
Rear main angle of sharpening drill bits, degree
25
The length of the sharpened drill bit, mm
80..200
Overall dimensions (LxWxH), mm
270x220x215

Write a review

Note: HTML is not translated!
    Bad           Good
basic_captcha

Device for sharpening drills with the center and cuts VZ-384.P15

  • Product Code: VZ-384.P15
  • Availability: In Stock